|
|
|
|
|
|
|
|
|
|
|
|
| This item does NOT ship for free |
| Shipping charges will apply to this item. If you place your order now we will call with the shipping rate. If the rate is approved by you we will charge you the additional shipping. If the rate is NOT approved by you then we will cancel your order. If you do not wish to place your order now you can enter in the quantity you wish to order and your zip code in the Q&A section below and we will respond with a quote. |
|
|
|
| Can't find a matching part number? Find the piston size of your unit. Front Master Cylinders - check the top or bottom of the lever clevis for a stamped alphanumeric string. The last two digits in the string indicate the piston size in mm (EXAMPLE: ‘1PJK 15' = 15mm piston. In the case of ‘Radial-GP' pumps, you may see a ‘PR' or ‘/'' stamping, followed by a number. If the number is “19x18†or “16x18â€Â, the first number is piston size, the second refers to the pivot centers of the unit's lever). Rear Master Cylinders - for lever-types, check clevis area as above. If rod-actuated, check the entire body for the alphanumeric string or a string starting with ‘PS' (EXAMPLE: ‘PS12' = 12mm piston). |
|
|
| WARNING: Laws concerning this product vary from state/province to state/province. Your state/province may prohibit its use on public roads or restrict its use to novelty, show use, off-road areas, or race facility areas only. In some states/provinces off-road uses are also prohibited. The manufacturer and retailer assume no responsibility for any use or application of this product in violation of any applicable law. Before installing this product, please check your state/provincial and local/municipal laws and regulations. |
|
| The Q&A on this Product |
|
|
| QUESTION: Hello. What is the distance center to center for the two mounting holes? I'm delinking the brakes on a '76 Moto Guzzi and need to go to a smaller rear M/C since it'll actuate only the rear F08 caliper. I'm considering 10.4776.83 since it already has the rod. Good match? Any advice? Thanks! |
| ANSWER: 40mm. This is a 13mm master cylinder and should work fine. |
|
| QUESTION: have you got this part in stock? Do you have a seal kit for this cyinder? |
| ANSWER: The part is in stock but no kits are available. |
|
| QUESTION: Hi I am using a Brembo thumb brake connected to the front reservoir, eliminating the rear. The problem I have is I need a rear master cylinder that has a pushrod that would work on my Kawasaki 2002 ZX-6R
The Brembo master cylinder installed cannot accommodate the existing pushrod, it just sits loosely - it would works, but unexceptable for track use. Thanks Ashif |
| ANSWER: Dear Ashif,
I cannot answer this question but if you please call Jason at Brembo North America at 800.325.3994. I hope he can help you. If he gives you a part number let me know as you cannot buy direct from Brembo.
Sincerely,
Jolene Waibel |
|
|
|
| Ask your question here: |
|
| Your email (so we can send you the answer): |
|
|
|
Event Photos
powered by WordPress e-commerce company