|
| RISERSET PULL BACK 4" M12 |
DISCONTINUED. Cannot be returned or exchanged. These are some of the coolest billet risers ever. They will add an awesome hot rod look to your bike. Made of super strong steel, polished and perfectly chromed. 12mm bolt application. Universal - Custom Applications for 7/8" (22 mm) and 1" (25 mm) handlebars |
| |
| Item no. HH-56-0342 |
| Today's Sale Price: $123.27 |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| WARNING: Laws concerning this product vary from state/province to state/province. Your state/province may prohibit its use on public roads or restrict its use to novelty, show use, off-road areas, or race facility areas only. In some states/provinces off-road uses are also prohibited. The manufacturer and retailer assume no responsibility for any use or application of this product in violation of any applicable law. Before installing this product, please check your state/provincial and local/municipal laws and regulations. |
|
| The Q&A on this Product |
|
|
| QUESTION: Thanks for the reply,
But I'm still not clear on the specs. If these are 4" risers then is that the total height from the tripple tree to the center of the handlebar mounting holes or does that mean that these risers add 4" to the existing approximately 2" stock risers? Also, these risers are curved rearward so they should provide some pullback from the stock position also - do you have a number for that dimension?
If you don't have the info handy maybe you could send me a link or other info for the manufacturer so I could find out from them. I've bought two risers already, one from you and one from Scootworks and neither one is "right" for me so I want to stop "buying and trying" which is getting both expensive and time consuming.
If no other published info exists for these could you please send me their actual measurements (vertically from the bottom of riser to bottom of handlebar cutout and, standing the riser up vertical, the distance from the tripple tree bolt hole to the back edge of the handlebar cutout, which will be a horizontal measurement) and I'll do the calculations myself?
Thanks,
|
| ANSWER: The total height is 5.5 inches and the height from bottom to center of the mounting hole for the handlebar is 4.75 inches. There is a SLIGHT pull back to the risers however we do not have any measurements on the pull back.
Thank you. |
|
| QUESTION: Hi, can you tell me the approximate ammount of added height and pullback from stock on a 05 Yamaha 1100 V-Star Classic/Silverado? (the one with the "batwing" stock riser) I recently purchased the Gen-Mar Y-125 from you and it just doesn't give me quite enough of either height or pullback.
Thanks, |
| ANSWER: it gives 4" added height. Thanks |
|
|
|
| Ask your question here: |
|
| Your email (so we can send you the answer): |
|
|
|
Event Photos
powered by